My first real project in NL2. It follows the blueprint of the real coaster (12m high and same length/width), but it doesn't follow the exact layout of their models.
Bit disappointed with this ride to be honest. The presentation overall seemed pretty nice but the ride itself lacked - even for a family rollercoaster.
The first half of the ride was pretty nice - the tight turns and the drop. I also enjoyed the double up - although that would've been cooler if you were already spinning. You did a good job on the scenery too - felt very realistic.
The main thing was the lack of a decent amount of spinning section - the ride just spent way too long locked into position! This meant the ride just didn't feel better than the original design in any way - personally I'd have liked to see you unlock the spinning after the first drop.
The ground lattice was a nice touch of realism - however it served almost no purpose. The vast majority of supports connected into the ground at points other than where the lattice was and that was a bit of a disappointment.
To be honest though these rides are insanely tricky to get right and do well so it wasn't such a bad effort. Look forward to you creating something not so 'niche'!
Home
Contact Us
Login
Register
Store
Exchange
Browse The Scrapyard
Forum
Donate
