[phpBB Debug] PHP Warning: in file /websites/coastercrazy.com/exchange/detail.php on line 554: Undefined variable $reviseButtonCode Plunge by Connor is a track for NoLimits Coaster 2 - CoasterCrazy.com
This needed some technical work - these are my thoughts.
Turnaround at the top of the lift was far too fast - you need less of a pre drop and more of a gradient leading into the holding break.
Dive loop (and the immelman) weren't shaped especially well which led to high lateral forces. Dive machines don't fully invert until after the apex of the element. Both your inversions needed to finish the twist later. The immelman needed to exit at an angle to the entry, not 180 degrees from the entry.
MCBR probably needed catwalks ect. Look at the major dive machines and try to emulate them.
Supportwork needed some work, again look at the major dive machiens for some hints - plus make sure you use B&M connectors - you can change this by selecting the track connector node and going into the support properties menu.
Keep making ride sthough, this wasn't absolutely terrible (better than some of my first creations) just need some more work and care!
Feel free to pm me about your rate [:
Technique 2.75
Adrenaline 5
Uniqueness 4
Realism 3.5
Rider Value 3.75
Average 3.8
What did you think?
Your ratings help the community discover great tracks
Detailed reviews earn you exchange points!
Want to leave a review?
Download this track first, then come back to share your rating
3.80
Average Rating
19
Downloads
1
Ratings
0
Likes
Sponsors
Did you know? Active community members enjoy an ad-free experience! Learn how ›
Rate 80%+ of your downloaded tracks (min 40 downloads)
Post at least 25 forum topics or replies in the last 90 days
Home
Contact Us
Discord
Store
Exchange
Forum
Turnaround at the top of the lift was far too fast - you need less of a pre drop and more of a gradient leading into the holding break.
Dive loop (and the immelman) weren't shaped especially well which led to high lateral forces. Dive machines don't fully invert until after the apex of the element. Both your inversions needed to finish the twist later. The immelman needed to exit at an angle to the entry, not 180 degrees from the entry.
MCBR probably needed catwalks ect. Look at the major dive machines and try to emulate them.
Supportwork needed some work, again look at the major dive machiens for some hints - plus make sure you use B&M connectors - you can change this by selecting the track connector node and going into the support properties menu.
Keep making ride sthough, this wasn't absolutely terrible (better than some of my first creations) just need some more work and care!
Feel free to pm me about your rate [: