G Force

Another stupid problem with no limits that ruined a coaster. I'm making a coaster g's are fine farther in the coaster and a bank that was 1.2G went up to 2.7G for no reason. I didn't do any speed increase so i don't know whats happening and then another is the bank 1.3 one time. The next its 1.8g. the next is 1.6g. I'm wondering why the forces just randomly do that? Because when it comes to rating for someone it might be green and then another it might be red and have a whole diffrent rating.

Either you're hitting a bump or your FPS are skipping.

[A7]

I would say that Freddie is most likely correct. That is what I would have guessed. However, I did have some trouble similar to this a long while ago. Its probably not be the same as yours though. A while back I was working on a long wooden coaster (~2 1/2 minutes of track after lift-hill). Towards the end of the ride, g-forces would vary greatly.

Perhaps you could post some screen shots? What version of NoLimits do you have?

I think it's probably a combination of the things that freddie mentioned. Your framerate is probably such that sometimes a frame is loaded at the instant of the bump, and other times just shortly before and after (as in, the bump is hit in between the frames that you see). Although, screenshots would be nice.

If you ran the track through tunnel maker or auto flanger or anything, it will have disabled the 1.6 friction, that may be the problem...