Mayhem - NoLimits

May I present you to my newest creation! MAYHEM

This is my experiment coaster. By that I mean that I will be building without any tools expect autoflanger.

Mayhem is an Intamin Looper it has two loops and two horshoe rolls.

So here you go!

I'm lovin' that twisted layout.

Originally posted by tiepilot35

I'm lovin' that twisted layout.

Thanks! It is really hard to build without ahg so the lats don't go wild... I now have allmost every lat under control. And it is also hard to build because my NL has had some weird problems, it shows that one of my turns has yellow G:s at 3 G:s but when I next open the track it stays at green 0_o

Vertical force? And what exactly do you mean? Your post is very confusing.

Yeah sorry about that... I guess I ment that on one of my flat turns at the middle of it when there is 3 vertical G:s it goes yellow. But when I shut the Nolimits and start it again it isn't showing up as yellow anymore. It also doesn't show up as yellow again if I go to the next train...

beautiful... i just have to test this for ya [:)] coasterking1993@aim.com

Originally posted by coasterking1993

beautiful... i just have to test this for ya [:)] coasterking1993@aim.com

One Mayhem coming![hello]

[Coasterkidmwm]

Corkscrew looks a tad compressed.

Originally posted by FIN

Originally posted by coasterking1993

beautiful... i just have to test this for ya [:)] coasterking1993@aim.com

One Mayhem coming![hello]

ok, ill check my email later at home and try to test tonight because my school doesnt have aim [:D]

I'll gladly test, if you would like.

Originally posted by Coasterkidmwm

Corkscrew looks a tad compressed.

Yes, I know I just made very simple ones at first and I am going to work with them. But they are very smooth and have reasonable G:s (lats are under 1)

And Xpress could you send your E-Mail adress via PM?






What do you think about the supports so far?

Here are some new pics:

http://www.nolimitsdevcenter.net/p4788

What do you guys think about the cartextures and flanges that I made?

[redsmoke]

I would certainly suggest completing connectors to the track and making the lift supports less wide. Other than that, seems ok to me.

I think perhaps the flanges are too large in diameter for the support you have shown in the last picture on your NLDC.

Thanks for the comments. Here is the layout and new cartexture:

http://www.nolimitsdevcenter.net/i37743

http://www.nolimitsdevcenter.net/i37744