Board index Roller Coaster Games Hard Hat Area Vulcan (B&M Floorless)

Vulcan (B&M Floorless)

The Hard Hat Area is the place to post construction news about your ride, so this is the place to hype your future upload!

Post December 12th, 2009, 11:47 pm

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
Here's a quick update. The Station is now finished.

Image

Here's more pics of the Immelman.

Image

Image

Image


Names for the Ride are now up in the air. Any suggestions??
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 12th, 2009, 11:58 pm

Posts: 2046
Points on hand: 3,043.00 Points
Location: USA


Post December 13th, 2009, 12:14 am

Posts: 1580
Points on hand: 2,736.00 Points
Yeah the banking is too late on the pull out it needs to be a lot more earlier. And as for a name, I don't know.

Post December 13th, 2009, 12:30 am

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
Which is better?

Image

or

Image
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 13th, 2009, 12:34 am

Posts: 1149
Points on hand: 1,004.00 Points
Location: Virginia, USA

Post December 13th, 2009, 12:34 am

Posts: 2046
Points on hand: 3,043.00 Points
Location: USA

Second one's better, but it still needs to be less banked at the top, look at that pic of Wildfire I posted.

Post December 13th, 2009, 12:49 am

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
Should the absolute top be almost verticle?
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 13th, 2009, 12:52 am

Posts: 1580
Points on hand: 2,736.00 Points
^ No. The second one is better but it's a really gradual unbank. You need to make it a bit snappier.

Post December 13th, 2009, 12:54 am

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
So make it unbank faster. Should the banking almost be gone where the first support is??
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 13th, 2009, 12:56 am

Posts: 1580
Points on hand: 2,736.00 Points
Wait I think I made a mistake. I think you started the banking too early. It has to be when you reach around 160 degrees, you started banking when you were like at around 120

Post December 13th, 2009, 1:03 am

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
Image

is this better?? Banking starts later and ends quicker.

It starts baking at the 2nd nod from the Supports on the far left. The angle made it difficult to tell.
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 13th, 2009, 2:15 am

Posts: 1580
Points on hand: 2,736.00 Points
By unbank I didn't mean completely back to 0 degrees, B&M doesn't usually do that, that's more Gerstlauer-y. This is what I mean:

Image

Post December 13th, 2009, 2:21 am

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
Yours is different though, Mines practically sends it back the same way it enters. Yours send it to the side of where the train enters, so won't the banking be naturally different?

Entrance and Exit are only about 10ft away.
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 13th, 2009, 2:30 am

Posts: 1580
Points on hand: 2,736.00 Points
Yeah that's the problem because B&M usually makes the direction change on their Dive Loops/ Immlemans.

Image

Image

Image

But since yours travels in the same direction, try to make your Immleman
look more like D?????????monen's

Image

Post December 13th, 2009, 5:06 pm
slosprint User avatar
Premium Member
Premium Member

Posts: 3649
Points on hand: 5,728.00 Points
Location: MA, USA
for a name perhaps Power Surge? that would explain the bright yellow track
Boulder Dash was the only good roller coaster.

"or if you're when the hydraulic fluid was dumped out of the motor is goes 200ft up the tower and is like "LOL nope"" - CKMWM 2016

Post December 13th, 2009, 5:18 pm

Posts: 323
Points on hand: 1,492.00 Points
Location: Culver City, CA, USA
http://www.coastercrazy.com/track_excha ... ?tid=16381

Ride uploaded. Name is Vulcan. Blue has been changed from Blue to a Rusty-red-brown.
Sometimes you gotta sacrifice a little bit of yourself to get the job done.

Post December 13th, 2009, 6:49 pm

Posts: 1240
Points on hand: 6,869.00 Points
Location: New Jersey, USA
Nice ride. I am going to leave rate.

**Rating is done check it out

Previous

Return to Hard Hat Area

 


  • Related topics
    Replies
    Views
    Last post
cron