Im making an Intamin blitz coaster which has a drop more than 90 degrees. I tried using curved geometry pieces but it takes up a lot of space vertically and comes out really snappy in the editor. How can it be done?
This is never the answer. Just increase the angle of the curved geometry at the crest of the lift (after the chain) until the force section curves the way you want it to.
Originally posted by GerstlCrazy Cool! The name is Fly Over Rainforest? I was under the impression the name was Green Coaster Goes Fast Goes High Has Clockwise Loop Has Straight Upside Down Four Seats Two On Each Side Fast Coaster?
This is never the answer. Just increase the angle of the curved geometry at the crest of the lift (after the chain) until the force section curves the way you want it to.
What do you mean never the answer, I always hand build mine!
Last edited by Rickrollercoaster on July 2nd, 2014, 8:22 pm, edited 1 time in total.
This is never the answer. Just increase the angle of the curved geometry at the crest of the lift (after the chain) until the force section curves the way you want it to.
Here's the deal, Newton building help will always be given to those who ask for it, but handbuilding help, will be given to those who deserve it. (Brownie points if you get the reference!)