This coaster was also built by me about 1 year ago. It is better than most recreation of the ride that have been done but doesn't contain nearly as much scenery as my TTD recreation.
Model:
Inverted, outside-looping coaster
Structure: Steel tubular track supported by 300 steel columns
Features: Six upside-down turns: one vertical loop, two inverted corkscrews, a zero-gravity roll and a "cobra roll" that turns riders upside down twice
Time: Approximately 2 minutes, 16 seconds
Speed: Approximately 57 mph
Coaches: Eight rows of passengers seated four-across
Three 32-passenger trains
Vehicle Design: Single ski lift-style seating with shoulder harnesses and lap belts
Ride Capacity: Approximately 1,800 riders per hour
MANUFACTURING
Investment: $11.5 million ride project
Ride Manufacturer: Bolliger & Mabillard (B & M), Monthey, Switzerland
OK, here is why your grade is just OK, 1. station is about 20 ft. off ground, not like 8. 2nd, block breaks are too high, in real life, your going about 25 into them, yours is 16ish. 3rd, ride was too slow and boring between 5th and 6th inversion and finally your helix is mega wrong, you need to spend a day modifying that. (like start over)
This was a very good recreation, it was much better than the other one on this site as far as layout accuracy. Just needed some smoothing on the corks and it would have been a perfect Raptor recreation.
This ride had more bumps than any other coaster i have rode. You really do need to practicing on your track smoothing. Plus some of the supports may need a little work on them. Keep up the good work and just PRACTICE
I agree with the first review on here.. This did seem slower than the actual ride and the corkscrews were a little funky but other than that pretty good... i give a THUMB up
Home
Contact Us
Login
Register
Store
Exchange
Browse The Scrapyard
Forum
Donate
