AHG start banking problem

I'm making a launched ride, and I've tried many times to ahg part of the track. Instead of starting and ending with the banking at zero degrees, the element (post-ahg) starts at 16 degrees, and ends at zero how it should be.

Any suggestions?

Well, if theres a low amount of track segments this is going to happen.

So try more segments and if that doesnt work then try to color more of the beginning of the brack black before ahg.

Well the segments that I'm doing go from the launch to one of the MCBR's. I can't really add more segments then. And I've tried setting it all black, then the first few segments red and last few green, but no avail.

Ok, from what I used to do with ahg, I never used red and green segments, and things were usually good. Try getting rid of the red and green and try again.

Just bank the beginning of the track the opposite way that the ahg is bending it before you run it through. After some trial and error you should be able to get it right to 0 degrees. The first segment should be black too.

I set the final amounts of segments higher, and I finally got it to work. Thanks.

Np