Auto flanger problem

At the bottom of support which is connected to fundament nodes, the y-coordinate = 0.2-0.5 m. (Depending on the tube size)

But the Auto-Flanger thinks the y-coordinate = 0
which causes some flanges to be placed wrongly.

To solve the problem, I temporarily use free nodes instead of fundament nodes. I think swapping the free nodes is much easier than fixing the flanges.

I couldn't find anything bout this in the previous topics, so I just wanted to mention the fact.

[hyyyper]

You could also place an extra free node between the actual support beam and the footer. Then connect the free node to the footer and the rest of the structure and place it on the same position of the footer node.
Problem solved.