Banking Problem

I have a problem that occurs quite often.


In the yellow box, there is some banking and I have no idea why or how to fix it. The 2 nodes at the end of the track section are both a 0 degrees. Can anyone help?

Continuous roll is on, isn't it?

The two buttons that say 'rel roll' and 'con roll,' make sure the 'con roll' button is off on those nodes in question.

Con roll, when selected on a node, varies the banking on the track segment before and after the select node to smooth the transition and make it gradual.

Or you can leave Con Roll on and adjust the banking to either side a bit to get rid of the wobble.

I believe I remember something about Con Roll using fractions of a degree based on the previous and following nodes, so banking to compensate might not be a good idea. Redunzelizer figured all this stuff out back in the day.

Yes, con roll was on and now that I turned it off, the problem is fixed. Thank you guys